Connect the device to an adequate electrical circuit.
Immediately after connecting the device, “stand by” mode is activated. A sensor will activate the diodes by placing your hand into the lamp for 120 sec. Pulling your hand out of the lamp anytime will shut down the diodes.
Depending on the time needed for curing gel or gel polish, apart from the basic.
120 seconds operation mode, the lamp has four alternative operation modes:
- 10 seconds operation mode
- 30 seconds operation mode
- 60 seconds operation mode
- 99 seconds "Low heat mode"
10, 30 and 60 seconds operation modes are activated by pressing the designated mode activation button, marked with a corresponding label (10s, 30s or 60s). Once the desired mode has been selected, the diodes will start emitting light.
After the selected time expires, the diodes will stop emitting light.
The “Low Heat Mode” is activated by pressing the 90 seconds button. This mode cures gels or gel polishes for 90 seconds, divided into three continuous phases:
* Phase one takes place with 1/3 of the total lamp power, lasting for 30 seconds
* Phase two takes place with 2/3 of the total lamp power, lasting from the 30th to the 50th second.
* Phase three curing takes place with the lamp on full power. This phase starts from the 50th second, lasting until the 99th, after which the diodes stop emitting light.
Each mode can be interrupted by pressing its activation button.
The lamp has a timer memory function. By pressing 10s, 30s or 60s buttons for 2 seconds, the lamp will memorize the selected timer that will be active whenever the selected time ends or the client pulls his hand out of the lamp.
Example: By pressing the button “10s” for 2 seconds, the number 10 will show up on display, the diodes will emit light, and the timer will count down from 10 to 0. By pulling the hand out of the lamp, the diodes will stop emitting light, and the timer will get back to 10s, which means that the previously selected timer is active again and will start counting down from 10 when the client gets his hand back into the lamp.
Deactivation of timer memory can be done by shortly pressing its activation button.
The lamp also has a dual power&rdquo mode.
This mode changes the basic power of the lamp. It can be activated by activating 10s, 30s or 60s timer and then holding the 99s button for 2 seconds.
This mode and all other modes can be interrupted by pressing its activating button for a short time.
